超碰在线人人爱I日批网站免费观看I亚洲三级黄I天天射天天色天天干I日韩精品中文字幕一区二区I国产 色

What engineering plastics have good thermal conductivity? Most of the traditional thermal conductive plastics are thermal insulation materials. The thermal conductive plastics developed by Zhaoke company bring new key to this field. The commercial application of thermal conductive plastics began in 1998, and more than one million pieces have been made. The products have been successfully applied in various fields, such as consumer electronics, power electronics, cars, motorcycles, lighting, medical equipment and other appliances.

Thermal conductive plastics are based on engineering plastics and general plastics, such as PP, ABS, PC, PA, LCP, PPS, peek, etc.

The typical thermal conductivity planning is 1-20w / m-k, and some grades can reach 100W / m-K. This value is about 5-100 times that of traditional plastics, and the general thermal conductivity is only 0.2w/m-k. This conductivity is also suitable for some metals, such as stainless steel with a thermal conductivity of 15W / m-k and some cast aluminum alloys with a thermal conductivity of 50-100w / m-K.

Compared with the traditional polymer materials, the thermal conductivity and impact resistance are poor. It is mainly used to replace some metal or ceramic parts which have strict requirements on the size of products, such as micro electronic components, optical components, mechanical components and medical components. When using elastomer as base material, it can be used as gasket, shock absorber or touch material.

By combining the simplicity of thermal conductive plastics with excellent thermal conductivity, the same heat transfer ability of some metals or ceramics can be completed by injection molding. Together, this new material can provide planners with more planning, and the parts are only half as heavy as aluminum products. Processing with thermal conductive plastics can shorten the molding cycle by 20 to 50 percent, and its inherent low coefficient of thermal expansion can reduce product shortening.

Source: Jiangmen engineering plastics http://m.nbkaifa.com/